The Scorpion Installed In-Ground lift is semi-recessed in your shop floor. This is a semi-inground installation is an ideal solution for those shops that perform a lot of tire service and Brake Service. This is an installed version of the ScorpionTJ12 service jack and it offers a perfect combination of speed, efficiency, ease of use and value. The Scorpion Installed lifts are much less expensive than your standard above- ground options or for that matter the in-ground options too.

These jacks are designed to lift the vehicle across the axle using the lifting saddles provided (Low/Med/Hi). So you lift the whole front end or axle assembly in one go. There is a tire spotting dish for quick set up, and a remote control to allow the operator to check the load.

There is a built in lock for safety and other convenience features.

The lifts come with a control station housing the pump unit and a 20 Ft. Remote control so the operator can spot the load.

Features:

Choose between:

Features and Benefits:

• Start-Stop pressure switch control
• ASME safety valves fully enclosed belt guard
• Tank drain and discharge valve
• 208-230 volt, single phase
• 2 year full warranty

No magnetic starter required. This compressor comes complete with everything you need to optimize your work and minimize down time. 18.5 cfm @100 PSI.

Features and Benefits

• Rugged, durable and reliable 12 Volt jump starting for professional applications
• Delivers 1700 Peak Amps, 425 cranking amps of jump starting power
• Long, 46" #4 gauge heavy duty cables allow the unit to be positioned in the ideal location during jump starting
• Volt gauge provides an accurate, detailed state of charge for the onboard battery
• Built in charger will never get lost and works with any US extension cord
• NOT compliant for California use, order SOLJNC660C instead

Trusted by professionals the world around as their go-to jump starter, the SOLJNC660, with Clore PROFORMER battery, will not disappoint. Ideal for use in a wide variety of jump starting environments, including automotive, marine and industrial – try it once and you'll see why so many technicians will accept only the JNC660. Includes a 12 volt outlet to power accessories and a Product for Life coupon that allows the end purchaser a one-time product repair for a low, fixed fee, regardless of reason for damage/problem. 1 year limited warranty.

Supercedes: KKJ990681

The 5950 Dual Wheel Adapter must be used when using the Big Truck Tire Step on Dayton and dual wheels.

This adapter provides extra stability by resting against the tire when there is no rim to rest against. The Dual Wheel Adapter is included with the 5800 Super Single 2-Step and the 5300 Super Single 3-Step.

The Dual Wheel Adapter can be easily attached to any Big Truck Tire Step by sliding the adapter’s two attachment posts over the step’s rear stabilizing posts. Secure the adapter with the included screws and nuts.

Super Single Model numbers 5800 and 5300 come pre-drilled for the adapter. If using the dual wheel adapter with model numbers 5500 or 5100 you must: 1) Remove vinyl caps. 2) Slide on adapter and mark hole placement. 3) Drill holes in the stabilizing posts. 4) Attach Dual Wheel Adapter.

*Note: This is the adapter bar only. Steps are sold separately.