Features and Benefits:
Standard side wheel manifold set, includes three 36" standard hoses with 1/4" fittings.
Perform pre-trip, post-trip and preventative maintenance inspections with the Pre-Trip Inspection Tool, a 4-in-1 tool that allows drivers and technicians to visually inspect tire tread depth, brake stroke, brake shoe thickness and windscreen damage. When not in use, the Pre-Trip Inspection tool can easily fit in a pocket or on a keychain.
Performs the following inspections:
A. 5/32” Steer tire depth
B. 3/32” drive and trailer tire tread depth
C. ¾” maximum size of windscreen chips
D. 9/32” brake shoe thickness
E. 2” maximum stroke for short stroke chamber
F. 2.5” maximum stroke for long stroke chamber
G. Keychain hole
*Note: Measurements for A, B & D are set 1/32” greater than the legal requirements to allow driver to take corrective action before the vehicle is out of compliance.
Manufactured in the USA
Testimonial
"During a roadside inspection, I avoided a citation for the chip in my windshield. Using my Pre-Trip Inspection Tool I measured the chip and showed the officer that it was less than ¾”. He let me go with no citation. I love this tool!”
-Jon Hope (Rowdy Farms)
Use this handy adapter, your Square Wheel Industries Trailer Light Tester, and your #019050 SAE 7-Pole plug output tester to power the light cords needed for testing.
Don't change another tire the hard way! The HD-26 Clever Lever® puts science back in this chore by providing just the right tool to remove and replace tires easily and safely. The Clever Lever® allows one person to readily move tires up to 300 lbs., helping to prevent back injuries and other costly insurance claims. Simply roll the Clever Lever® under the tire, then lift and pull. To replace a tire, simply push it back in, rotate and tilt for quick alignment with the studs. The HD-26 Clever Lever fits tires from 36" to 48". The Clever Lever® comes in two models that fit everything from light/medium duty pickups to heavy-duty tractors and trailers.
Specifications:
30" length x 19.5" width x 4" height; 21 lbs shipping weight
TSI #6067 - MKHMV Back Buddy II Adapter
Only one required. Adapter connects directly to 8 stud inboard hubs. Studs are 5-1/2" on center for Hummer/Humvee geared hubs