Are you looking for:

1,000 lb. Capacity Low-Lift Transmission Jack

Features and Benefits:

  • Universal mounting head with adjustable brackets, tilts front to back and side to side
  • Height range: 6-1/2" to 29-1/2"
  • Safety chains hold the load securely even while moving about the shop
  • Wide wheel base with four swivel casters, and two handle grips make it easy to position under the vehicle
  • Safety overload prevents use beyond its rated capacity

Pump handle rotates a full 360 degrees for use in any position. Flash-chromed ram inhibits rust from entering the hydraulic system.

Stinger Truck Dual Wheel Dolly

Features and Benefits:

  • This 1,500 lb. capacity dolly will remove, transport, and replace dual wheel and tire assemblies without strain or struggle
  • Swivel casters, 3-1/2" front and 3" rear, provide easy maneuverability
  • Floor space is 43" x 42"
  • No. 1769 hydraulic jack provides over 6-1/2" of lift and tilts wheel assembly 7 degrees to prevent damage to wheel seal
  • Includes a 6' support chain to hold load in place
GM Car Ball Joint Adapter Set

Features and Benefits:

  • 18 adapters included to remove and install ball joints
  • Application cross reference and instructions included
  • Works on upper and lower ball joints on: 1996 – 2008 Chevrolet, Buick, Pontiac, Oldsmobile, and Cadillac cars with press in ball joints
  • For use with OTC USA made C frame
  • Does not include the 7248 C-Frame press

Includes reference guide thru 2008 referencing press fit or bolt in ball joints, adapter application diagrams and charts, and quick reference charts.

Swing Down Step 3-Step Single Handle w/ Adjustable Stake (Flat Black)

The Swing Down Step flatbed ladder is especially useful on flatbeds and dump trucks where easy and safe access has always been a problem. Thanks to its universal design, it can be mounted anywhere you can mount a pocket.

FEATURES & BENEFITS:

  • Built-in Grab Handle
  • 2-Way Gas Spring allows for controlled movement up and down
  • Adjustable Model fits all standard pockets
  • Can be padlocked in place
  • Approximately 39" long step section brings it close to the ground for easy access
  • Special tread design provides sure traction
  • Design allows three point contact
  • Latches securely in upright position when not in use
  • Easily moved from vehicle to vehicle
  • Easily installed on new or existing vehicles
  • Heavy Duty steel construction for long life
  • Black powder coat

NSN 2541-01-531-4064

Swing Down Step 3-Step Single Handle Solid Stake and Mounting Bracket

The Solid Stake Swing Down Step flatbed ladder is especially useful on flatbeds and dump trucks where easy and safe access has always been a problem. Thanks to its universal design, it can be mounted anywhere you can mount a pocket.


FEATURES & BENEFITS:

  • Built-in Grab Handle
  • 2-Way Gas Spring allows for controlled movement up and down
  • Can be padlocked in place
  • Approximately 39" long step section brings it close to the ground for easy access
  • Special tread design provides sure traction
  • Safety yellow powder coat finish
  • Design allows three point contact
  • Latches securely in upright position when not in use
  • Easily installed on new or existing vehicles
  • Heavy Duty steel construction for long life
  • Loading...