Are you looking for:

Fully Automatic Intellamatic Battery Charger

Features and Benefits:

  • 12-Volt, 60 Amp Wheel Charger
  • Program for Deep Discharge and Recovery with desulfation mode
  • Dead battery over ride switch to bring batteries above the 4 volt minimum for testing and charging
  • ESS provides clean stabile power supply for reflashing vehicle computer systems and extended electrical system testing
  • Automatically test and charges all types of batteries including AGM, GEL and Lead Acid
  • 270 Amp boost for help in jump starting vehicles
  • Made in the U.S.A.

The "Does Everything" wheel charger which has 60 Amp charge rate and 270 Amps of crank assist.  This unit also supplies clean standard power for reflashing and extended electrical system testing.  Charges automotive, Deep Cycle, AGM and Gel Cell batteries.

2 Jaw, 13 Ton Mechanical Grip-O-Matic Puller

Features and Benefits:

  • This 2 jaw puller has a 13 ton capacity
  • Maximum reach: 11"; Maximum spread: 12"
  • Screw size: 13/16" 16 thread x 12"
  • Jaw thickness: 9/16"; Jaw width: 1"
These pullers are forged from quality steel, heat treated, and subjected to rigorous tests which exceed their rated capacity.  This complete line of gear and bearing pullers, enables you to remove and install parts for fast, effective repairs.
8 Quart Painted Measure with Flexible Spout

Features and Benefits:

  • Designed for one hand operation
  • Thumb operated valve controls flow, flip action locks valve open
  • 14" flexible metal spout with tapered 1/2" OD tip swings into the necessary angle for hard-to-reach jobs
  • Recessed bottoms drain fully and guard against puncture
  • Rolled edge top helps prevent oil spillage

11-1/2" overall height.

Radiator and Radiator Cap Pressure Test Kit

Features and Benefits:

  • For use in testing radiators
  • For use in testing radiator caps
  • Confirms radiator leaks
  • Confirms cooling system leaks
  • Test radiator caps for proper operation
Multipurpose Bearing and Pulley Puller Set
Features and Benefits:
  • 2 – Forcing Screws (Live Center): 3/4"-16 x 6-11/16" and 3/4"-16 x 5"
  • 2 – Cross-bar Yokes: 3 pin-hole at 3-1/4" to 5-1/2", 2 pin-hole at 2-3/8" to 3-3/8" 2 – Clamp Bolts
  • 3 – Pairs of Puller Jaws: 1-3/8" Max, 1-5/8" Max, 1-3/4" Max
  • 1 – Pair of Jaw Pins with Ball Spring
  • 3 – Pairs of Capped Bolts
  • Spread: 3" to 5", Reach: 1" to 2-1/4"
  • Housed in a blow-molded plastic storage case
This multipurpose bearing and pulley puller set is for a wide range of pulling jobs, including: bearings, alternators, generators, power steering and crankshaft pulleys, timing gears, and harmonic balancers.This set includes drop-forged components, which can be used in a variety of combinations.
Loading...